Chariot Carriers cx 1 Spezifikationen PDF herunterladen (Seite 11)

51100967 - B

4.7 InstallInG the handleBar

A. Position the handlebar behind the carrier with the

handles pointing rearwards. (See image 1)

B. Release the quick-release levers on the Accessory

Cross Bar.

C. With one hand on each side of the handlebar, press

and hold the spring buttons in on both ends of the

handlebar. (See image 2)

D. Slide both ends of the handlebar into the upper frame

of the carrier. Allow the spring pins to pass inside the

upper frame.

E. Slide the handlebar into the upper frame until the spring

pins engage.

F. Verify that the handlebar is securely attached to the

carrier by giving it a sharp pull - it should not pull out.

G. Tighten the quick-release levers on the Accessory

Cross Bar

H. Repeat steps D-F to install the grips into the handlebar.

I. To remove the handlebar; Release the quick-release

lever on the Accessory Cross Bar. Press both of the

spring pins through the upper frame and pull the

handlebar out.

WARNING

Before each journey make sure that all

of the spring pins in the handlebar are

fully engaged.

Any load attached to the handle affects

the stability of the child carrier.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 21 22

Keine Kommentare

Chariot Carriers cx 1 Spezifikationen Seite 11